Free Cheat-test Samples and Demo Questions Download
Adobe exams Adobe
Apple exams Apple
Avaya exams Avaya
Check Point exams Check Point
Cisco exams Cisco
Citrix exams Citrix
CIW exams CIW
CompTIA exams CompTIA
EC-Council exams EC-Council
EMC exams EMC
Exin exams Exin
Fortinet exams Fortinet
Hitachi exams Hitachi
HP exams HP
IBM exams IBM
Isaca exams Isaca
ISC exams ISC
Juniper exams Juniper
LPI exams LPI
McAfee exams McAfee
Microsoft exams Microsoft
Oracle exams Oracle
PMI exams PMI
Riverbed exams Riverbed
SNIA exams SAP
Sun exams SAS
Symantec exams Symantec
VMware exams VMware
All certification exams

HP HP3-C29 Exam -

Free HP3-C29 Sample Questions:

Q: 1
What does it mean when a <Supply> Very Low message appears on the device control panel?
A. The user must replace the specified supply.
B. The specified supply has reached the estimated end of life.
C. The specified supply is at or below 20% capacity.
D. The device will not accept any new print jobs until the specified supply is replaced.
Answer: C

Q: 2
You have powered on the HP LaserJet Enterprise M4555 MFP after replacing the encrypted hard drive, but the product will not boot up to a Ready state What is the first thing you should do?
A. Replace the encrypted hard drive again
B. Run a Cold Reset from the pre-boot menu
C. Remove and replace the formatter board
D. Verify that the latest firmware has been downloaded on the replacement hard drive
Answer: D

Q: 3
A customer complains that copy jobs using the ADF have lines on the output, but copy jobs from the flatbed look fine. What is the most likely reason this is occurring?
A. The ADF rollers are not rotating at a consistent speed
B. One or more of the LEDs used for ADF copying have stopped working.
C. The scanner is not in the correct location for ADF scanning.
D. A small amount of dirt or a smudge is on the ADF glass.
Answer: D

© 2014, All Rights Reserved