Free Cheat-test Samples and Demo Questions Download
Adobe exams Adobe
Apple exams Apple
Avaya exams Avaya
Check Point exams Check Point
Cisco exams Cisco
Citrix exams Citrix
CIW exams CIW
CompTIA exams CompTIA
EC-Council exams EC-Council
EMC exams EMC
Exin exams Exin
Fortinet exams Fortinet
Hitachi exams Hitachi
HP exams HP
IBM exams IBM
Isaca exams Isaca
ISC exams ISC
Juniper exams Juniper
LPI exams LPI
McAfee exams McAfee
Microsoft exams Microsoft
Oracle exams Oracle
PMI exams PMI
Riverbed exams Riverbed
SNIA exams SAP
Sun exams SAS
Symantec exams Symantec
VMware exams VMware
All certification exams

Nortel 922-098 Exam -

Free 922-098 Sample Questions:

1. A customer has installed a Communication Server 1000 Rls. 5.0 system with 800 IP telephones. All telephones at the site are registered to a single stand-alone Signaling Server. This site has three media cards installed. During peak hours, the customer reports IP telephone registration failures. What would you add to the network to ensure full redundancy for IP telephones?
A. a redundant Call Server
B. a Layer 2 ethernet switch
C. TPS Follower Signaling Server
D. additional DSP resources in the form of daughterboards or VGMC cards
Answer: C

2. While attempting to log into a Communication Server 1000 Rls. 5.0 system using Element Manager, you receive the following message:
WEB3003: Destination IP address cannot be reached, initial RPC fail.
Which signaling server command will verify that both the ELAN link is established and the Call Server IP address is correct?
A. Use stat elnk from Overlay (LD) 137.
B. Use pbxLinkShow from "oam>" shell of the Signaling Server.
C. Use the stat elnk command from "oam>" shell of the Signaling Server.
D. Use the itgCardShow command from the "oam>" shell of the Signaling Server.
Answer: B

3. A company has a multi-site Communication Server 1000 Rls. 5.0 system located in Mexico. There are two sites serving as a Main Office (MO) with three Branch Offices each. All systems are networked via a managed IP backbone. You have just received a trouble report indicating a network failure at one of the MO locations. Where can you configure the Public Switched Telephone Network (PSTN) as an alternative route to maintain inter-office communications until the network failure is addressed?
A. in Overlay (LD) 14 (trunk definition) using the CLI
B. in Overlay (LD) 16 (Route Data Block) using the CLI
C. in Overlay (LD) 86 (Route List Block [RLB]) using the CLI
D. in the Gatekeeper Server using Gatekeeper Element Manager
Answer: C

4. A customer has recently deployed a Communication Server 1000 Rls. 5.0 Branch Office solution. You want to verify that the onsite technician has enabled and defined the Network Connection Server (NCS) parameters correctly. Which Network Routing Service link should you access to view the NCS settings?
A. NRS server
B. tools
C. endpoints
D. H323 GW settings
Answer: D

5. A customer has recently deployed a Communication Server 1000 Rls. 5.0 system. While verifying the system configuration, you find that the customer inadvertently failed to change the default IP address of the Call Server Ethernet Link (ELNK) host. After modifying the ELNK host, which Overlay (LD) is used to re-enable the ELNK?
A. LD 17
B. LD 97
C. LD 117
D. LD 137
Answer: C

© 2014, All Rights Reserved