Alcatel-Lucent 4A0-110 Exam - Cheat-Test.com

Free 4A0-110 Sample Questions:

1. Which of the following debug statements can be used to troubleshoot if the OSPF adjacency is staying at xstart
state? Select two answers.
A. debug router ospf rtm
B. debug router ospf packet dbdescr
C. debug router ospf neighbor
D. debug router ospf packet hello
E. debug router ospf spf
Answer: B, C

2. What are the typical RIP related issues found during troubleshooting?
A. Interface filters
B. Broadcast/Multicast mismatch
C. Area id not match with neighbor
D. Group name not match with neighbor
E. Hop count too high
Answer: A, B, E

3. Which files have to exist on Compact Flash 3 during system initialization on the Alcatel 7x50?
A. iom.tim
B. boot.ldr
C. cpm.tim
D. config.cfg
E. bof.cfg
Answer: B, E

4. Which command should be used to enable automatic synchronization for all software images and configuration on the Alcatel 7x50?
A. admin redundancy synchronization boot-env
B. admin redundancy synchronization config
C. configure redundancy synchronize boot-env
D. configure redundancy synchronize config
E. It is enabled by default
Answer: C

5. Two routers are physically connected to each other over Ethernet port 1/1/1. Review the configuration information shown below. What state should the OSPF neighbor be in?

A. INIT
B. EXCHANGE
C. EXSTART
D. FULL
E. No OSPF neighbor
Answer: E

6. A policy is configured to redistribute four active static routes into ISIS. No ISIS route is received on the far end, what is the cause of problem?

A. Action accept has to be configured for entry 10
B. Default-action has to be configured as accept
C. Import policy should be configured under ISIS instead of export policy
D. Within entry 10, to protocol isis has to be configured
E. A prefix list has to be configured to filter the routes
Answer: A